For MRE What terminals can i connect a resistor to on J2 for 12v?
I want to use an old tacho
“General purpose high side push output, 5V/12V (internally selectable based on JP2 jumper) 250mA maximum”
Thanks
Jumper 2
-
WHENTHEFUNSTOPSSTOP
- Posts: 6
- Joined: Sat Mar 25, 2023 2:59 pm
- Github Username: NOFUN
- Slack: NOFUN
Jumper 2
You do not have the required permissions to view the files attached to this post.
-
Dron_Gus
- contributor
- Posts: 480
- Joined: Wed Nov 13, 2013 1:11 pm
- Location: S-Pb
- Github Username: dron0gus
Re: Jumper 2
JP2, not J2.
You do not have the required permissions to view the files attached to this post.
-
WHENTHEFUNSTOPSSTOP
- Posts: 6
- Joined: Sat Mar 25, 2023 2:59 pm
- Github Username: NOFUN
- Slack: NOFUN
Re: Jumper 2
Oops thanks Dron_Gus
I can solder the centre terminal to 12v terminal
for 12v output job done
I can solder the centre terminal to 12v terminal
for 12v output job done
-
WHENTHEFUNSTOPSSTOP
- Posts: 6
- Joined: Sat Mar 25, 2023 2:59 pm
- Github Username: NOFUN
- Slack: NOFUN
Re: Jumper 2
Just seen the board image of someone already doing this 
Thanks again
Thanks again