Is it much work to add 4 more Ignition outputs in the software? Instead of 8, I would like 12

And yes, Dual IGN/INJ Table would be nice too. Just add a Table Switch function

Regards from Norway!
The idea is for the project file to be universal and not depend on the board - remember we have two boards and some people are actually using their own boards. The default properties in the default firmware are already leaning towards the Frankenso board so I think we should be good as is.Snake____1 wrote:For example:
ignitionPins1 = bits, U32, 708, [0:6], "PA0",
to:
ignitionPins1 = bits, U32, 708, [0:6], "IGN1",