I login forum and see my last post is in 2018. After 6 years, I see many change in software/firmware side.
Currently I'm working on STM32F407VGT6 Cortex-M4 MCU Core Board Learning Development Board, so I think i can find my firmware here https://wiki.rusefi.com/Download/ . And then, I try firmware in STM32 Community Release, trigger that I'm planning to use is Mitsubishi 4g92/93/63 but unfortunately its only show 4G63 crank. AFAIK, few years ago I have been using this 4g92/92/63 (crank trigger on camshaft).
Please shed some light.
Thanks in advance.
///ahmettt
Hi all. I'm back!!!
-
matt
- donator
- Posts: 275
- Joined: Fri Aug 26, 2016 11:32 am
- Location: Malaysia
-
AndreyB
- Site Admin
- Posts: 14747
- Joined: Wed Aug 28, 2013 1:28 am
- Location: Jersey City
- Github Username: rusefillc
- Slack: Andrey B
Re: Hi all. I'm back!!!
What vehicle are you unable to start? I would assume that we still have our large collection of triggers https://github.com/rusefi/rusefi/wiki/All-Supported-Triggers
See also https://github.com/rusefi/rusefi/issues?q=is%3Aissue+4G63+is%3Aclosed
See also https://github.com/rusefi/rusefi/issues?q=is%3Aissue+4G63+is%3Aclosed
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
-
matt
- donator
- Posts: 275
- Joined: Fri Aug 26, 2016 11:32 am
- Location: Malaysia
Re: Hi all. I'm back!!!
Not try on real engine, just play around with trigger stimulator.
-
matt
- donator
- Posts: 275
- Joined: Fri Aug 26, 2016 11:32 am
- Location: Malaysia
Re: Hi all. I'm back!!!
I got it running on Proton/Mitsubishi 4G15 SOHC NA, sequence injection/ignition, and dual spark. Car has been dyno, result is impressive.
I planning to run lcd display to show rpm and other, but i see there is no lcd setting in this new firmware. Then I dig in oldest firmware https://github.com/rusefi/rusefi/releases/tag/2017.03.31_release_1.0.2 and this one got lcd setting.
How to make lcd working with new firmware?
I planning to run lcd display to show rpm and other, but i see there is no lcd setting in this new firmware. Then I dig in oldest firmware https://github.com/rusefi/rusefi/releases/tag/2017.03.31_release_1.0.2 and this one got lcd setting.
How to make lcd working with new firmware?