Actuators driver - Sergey89
-
Sergey89
- contributor
- Posts: 839
- Joined: Wed Sep 25, 2013 5:30 pm
- Location: Russia, Velikiy Novgorod
Actuators driver - Sergey89
Low side switches.
-
kb1gtt
- contributor
- Posts: 3777
- Joined: Tue Sep 10, 2013 1:42 am
- Location: ME of USA
Re: Actuators driver - Sergey89
Beware .1 to .01 ohm connections in P30. They can create tank circuit which can cause stepper motor failures by creating excessive voltage spikes.
Welcome to the friendlier side of internet crazy 
-
erich
- Posts: 21
- Joined: Tue Sep 03, 2013 4:55 am
Re: Actuators driver - Sergey89
How much current do you need to sink?
I used TLE6225G low side drivers with fault protection. Why re-invent the wheel on something this boring?
I used TLE6225G low side drivers with fault protection. Why re-invent the wheel on something this boring?
-
Sergey89
- contributor
- Posts: 839
- Joined: Wed Sep 25, 2013 5:30 pm
- Location: Russia, Velikiy Novgorod
Re: Actuators driver - Sergey89
I think about 1.5-2.0 Amp per channel. Infineon provides a lot of excellent solutions but it's harder to find.