[info] MX7-C-35PL-C11 35 pin connector

[AndreyB]

JAE 35 pin connector as used on my 2003 transmission controller module

https://svn.code.sf.net/p/rusefi/code/trunk/hardware/MX7-C-35PL-C11-connector/
https://svn.code.sf.net/p/rusefi/code/trunk/hardware/MX7-C-35PL-C11-connector/MX7-C-35PL-C11-gerber/MX7-C-35PL-C11_R0.1.zip

[AndreyB]

Board ordered as 2oz (takes more time)
Seems like Oshpart has improved their processing software to merge two drill files - previously they were only using one file and it did not go well for us.

[AndreyB]

board looks good

[kb1gtt]

That's good news. Looks good.

[AndreyB]

Finally getting back to making the harness but this board has the same silkscreen offset issue as http://rusefi.com/forum/viewtopic.php?f=4&t=687

While we are on that can we also make traces wider as well? Could be same issue with copper rings too large.

[kb1gtt]

Which revision is your board marked? We have a couple out there now are we sure you have the correct revision? Just trying to make sure we are all on the same page, as I don't have eyes on it.

[AndreyB]

That's a young board, only 0.1 was ever ordered - that's the revision i have.

[kb1gtt]

Oh, that's a different board. I changed the mask to 0.003, and fattened up the traces where I could. Draft committed.

[AndreyB]

I need your gerbers and your suby (once I get I larger garage)

[kb1gtt]

Gerbers generated and committed.

[AndreyB]

Gerbers generated and committed.

I know what i have forgotten to ask for

Can you please add pinout silkcreen on the back side as well? That's only needed for wiring half of the connector - the connector pads are covered by plastic.

[kb1gtt]

Silk screen added, and re-committed.

[AndreyB]

Silk screen added, and re-committed.

Thank you! Just ordered new boards.