[info] NGC 38 pin connector

Hardware inside and outside of the ECU
Post Reply
User avatar
AndreyB
Site Admin
Posts: 14727
Joined: Wed Aug 28, 2013 1:28 am
Location: Jersey City
Github Username: rusefillc
Slack: Andrey B

NGC 38 pin connector

Post by AndreyB »

A breakout board for Chrysler NGC connector.

Image

Image

https://svn.code.sf.net/p/rusefi/code/trunk/hardware/NGC_38_connector/

Case: https://www.tinkercad.com/things/dwXC24Jn2AG-single-ngc-38-box-v03

Order from Oshpark
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions

Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Top
User avatar
AndreyB
Site Admin
Posts: 14727
Joined: Wed Aug 28, 2013 1:28 am
Location: Jersey City
Github Username: rusefillc
Slack: Andrey B

Re: NGC 38 pin connector

Post by AndreyB »

the board is too tall this makes the shell for it HUGE https://tinkercad.com/things/fKZ8OSqr5zQ-38-draft-3

I guess we do not really need two holes for each wire, one would be enough. If we center the board and shrink it by 6mm on each side things should get smaller.
You do not have the required permissions to view the files attached to this post.
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions

Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Top
Post Reply

Return to “Dev: Hardware”