rusefi.com

Hello,

I have been trying to activate Ign 11 on my Proteus for use with LUA as PwmOut, and whenever I do add it in, I get the following error message

HARDWARE VALIDATION FAILED lua: unexpected startup pin state Ign 11 actual value=1 logical value=1 mode=OM_DEFAULT


I'm having a hard time understanding it all. I've been all through the settings to see if there's any chance I have Ign 11 activated in any other part of the tune, but it is not activated.

I have also tried using Ign10 and Ign12 instead and there are no issues, but only Ign11 seems to have the error message I've shown here.

Could someone please point me in the right direction of where to look?

Thanks,

Alex

https://github.com/rusefi/rusefi/wiki/HARDWARE-VALIDATION-FAILED

Dev: Software is a well, about developing firmware. This topic belongs in user support.

AndreyB wrote: ↑

Sat Sep 07, 2024 2:16 am

https://github.com/rusefi/rusefi/wiki/HARDWARE-VALIDATION-FAILED

Thank you. This helped me discover what I did wrong.

AndreyB wrote: ↑

Sat Sep 07, 2024 2:16 am

Dev: Software is a well, about developing firmware. This topic belongs in user support.

Sorry about that, I realized when I was going back to check for responses that I have it in the wrong place.