V8 wasted spark with 4 wire IAC
Posted: Sun Dec 13, 2020 8:12 am
Hello everyone,
I am in Australia. I enjoy using Tuner Studio and have done quite a few MS2 and other EFI conversions. I am still a mechanic at age, 57.
My current project is a V8 to run with wasted spark and batch fired injection in time with ignition table. I hope to use at least 1 knock sensor and 1 wideband O2 in closed loop. Also I want to use the GM 4 wire IAC.
Am I on the right track with RusEfi and Tuner Studio, please?
I use Dynosim 6 and Pipemax simulation software to write base starting maps which I have tested and proven, also.
Thank you.
I am in Australia. I enjoy using Tuner Studio and have done quite a few MS2 and other EFI conversions. I am still a mechanic at age, 57.
My current project is a V8 to run with wasted spark and batch fired injection in time with ignition table. I hope to use at least 1 knock sensor and 1 wideband O2 in closed loop. Also I want to use the GM 4 wire IAC.
Am I on the right track with RusEfi and Tuner Studio, please?
I use Dynosim 6 and Pipemax simulation software to write base starting maps which I have tested and proven, also.
Thank you.