2014 toyota tundra ?....
Posted: Sun May 24, 2020 12:01 pm
Has a 5.7l V8 DOHC with vvt,
I don’t know if I will tackle this project, as it’s about as complicated as it could get, 4 cams with vvt, Etb and electronic trans control.
Not sure that the current RUSefi Code can handle dual vvt,
And the trans control is another issue. But, if I were to try it, I think it would be in a piggy back configuration. Where I could take control of the injectors and coils, then maybe the ETB and vvt after that.
It’s my main transportation so I don’t want to break it.
Probably the best plan would be to build an interface board/harness to the stock ECU, that way I can intercept the signals I want to and leave the rest as is.
Any advice welcome!
I don’t know if I will tackle this project, as it’s about as complicated as it could get, 4 cams with vvt, Etb and electronic trans control.
Not sure that the current RUSefi Code can handle dual vvt,
And the trans control is another issue. But, if I were to try it, I think it would be in a piggy back configuration. Where I could take control of the injectors and coils, then maybe the ETB and vvt after that.
It’s my main transportation so I don’t want to break it.
Probably the best plan would be to build an interface board/harness to the stock ECU, that way I can intercept the signals I want to and leave the rest as is.
Any advice welcome!