Proteus loses communication.
Posted: Tue Apr 11, 2023 7:41 am
Got my Jeep 4.0 engine running in ignition only mode, but as soon as the engine is running the ECU stops communicating with Tunerstudio.
In device manager the USB status is unknown device when engine is running.
It's communicating fine when engine is not running.
I can make adjustments in TS and everything seems fine.
Setup:
LS1 coil near plug
36-1 trigger on crank, Hall sensor.
No cam sensor yet.
ECU is in car, 2feet away from coils.
ECU and coils/injectors are grounded to negative terminal on battery. Engine is grounded with a thick cable to both battery and chassis.
ECU gets 12V positive from a main relay near battery.
Updated firmware a month or so ago.
Latest TS.
Loses com. with Console also.
Will try without alternator belt on and ground the ECU to engine next.
Any other suggestions?
In device manager the USB status is unknown device when engine is running.
It's communicating fine when engine is not running.
I can make adjustments in TS and everything seems fine.
Setup:
LS1 coil near plug
36-1 trigger on crank, Hall sensor.
No cam sensor yet.
ECU is in car, 2feet away from coils.
ECU and coils/injectors are grounded to negative terminal on battery. Engine is grounded with a thick cable to both battery and chassis.
ECU gets 12V positive from a main relay near battery.
Updated firmware a month or so ago.
Latest TS.
Loses com. with Console also.
Will try without alternator belt on and ground the ECU to engine next.
Any other suggestions?