Page 1 of 1
m102 2.3 8v mercedes E190 PROTEUS
Posted: Fri May 20, 2022 6:28 pm
by subzero
i just finished building rusefi proteus for my car just a question,proteus can support 12 volt logic level from hall sensor,my hall a=sensor denso hondamatic works with 12 volts and outpouts 12 volt square signal,is good to go or i will fry the ecu?
Re: m102 2.3 8v mercedes E190 PROTEUS
Posted: Fri May 20, 2022 6:33 pm
by AndreyB
Yes proteus support +12 digital inputs
Re: m102 2.3 8v mercedes E190 PROTEUS
Posted: Fri May 20, 2022 7:41 pm
by subzero
thank you andrey
Re: m102 2.3 8v mercedes E190 PROTEUS
Posted: Sat May 21, 2022 7:25 pm
by subzero
placed 62 -2 triggerpulley and hall sensor
Re: m102 2.3 8v mercedes E190 PROTEUS
Posted: Mon May 23, 2022 6:57 pm
by subzero
just a question rusefi dont have squirts per cycle?
on speeduino used 2 squirts ,on 4 squirts i have very rich idle
Re: m102 2.3 8v mercedes E190 PROTEUS
Posted: Mon May 23, 2022 6:58 pm
by mck1117
subzero wrote: ↑Mon May 23, 2022 6:57 pm
just a question rusefi dont have squirts per cycle?
on speeduino used 2 squirts ,on 4 squirts i have very rich idle
can you post your tune at rusefi.com/online?
Re: m102 2.3 8v mercedes E190 PROTEUS
Posted: Tue May 24, 2022 2:26 pm
by MHTSOS
This sounds like 2 squirts per cycle = batch injection.
4 squirts per cycle = simultaneous injection
and 1 squirt per cycle would be sequential injection.
How are your injectors wired in?
Στάλθηκε από το VOG-L29 μου χρησιμοποιώντας Tapatalk