Hello everyone, I'm new to RusEFI and I want to make a microRusEFI. I downloaded hw_microRusEFI, but I can't understand its contents. After unzipping, there are many files, like in Picture 1
- 11.jpg (128.89 KiB) Viewed 8559 times
, I saw folders named gerbers. When I clicked into it, as shown in Picture 2,
- 22.jpg (206.96 KiB) Viewed 8559 times
I could see folders labeled R0.6.0, R0.3.4, etc. Are these version numbers? Is R0.6.0 the latest version? When I went into the R0.6.0 folder as shown in Picture 3,
- 33.jpg (207.9 KiB) Viewed 8559 times
there were several CSV files, which I assume are BOM lists. Now, if I want to proceed with PCB manufacturing, which CSV should I upload?
i use it on a motorcycle and it is equipped with a VR sensor. I want to know which version I should choose and which CSV file I should send to the factory for manufacturing.
I am a novice and can't understand the Gerber files and their corresponding BOM very well. There are micro_rusEFI.2022-04-09, micro_rusEFI.2023-06-xx, micro_rusEFI.2024-10-18_hall, micro_rusEFI.2024-10-18_vr and micro_rusEFI. Which one is what I need?
