rusefi.com

I login forum and see my last post is in 2018. After 6 years, I see many change in software/firmware side.
Currently I'm working on STM32F407VGT6 Cortex-M4 MCU Core Board Learning Development Board, so I think i can find my firmware here https://wiki.rusefi.com/Download/ . And then, I try firmware in STM32 Community Release, trigger that I'm planning to use is Mitsubishi 4g92/93/63 but unfortunately its only show 4G63 crank. AFAIK, few years ago I have been using this 4g92/92/63 (crank trigger on camshaft).

Please shed some light.

Thanks in advance.

///ahmettt

What vehicle are you unable to start? I would assume that we still have our large collection of triggers https://github.com/rusefi/rusefi/wiki/All-Supported-Triggers

See also https://github.com/rusefi/rusefi/issues?q=is%3Aissue+4G63+is%3Aclosed

Not try on real engine, just play around with trigger stimulator.

I got it running on Proton/Mitsubishi 4G15 SOHC NA, sequence injection/ignition, and dual spark. Car has been dyno, result is impressive.
I planning to run lcd display to show rpm and other, but i see there is no lcd setting in this new firmware. Then I dig in oldest firmware https://github.com/rusefi/rusefi/releases/tag/2017.03.31_release_1.0.2 and this one got lcd setting.

How to make lcd working with new firmware?