rusefi.com

Hi
I am currently on setting a BMW m52b28 turbo, injection full sequential.
My trigger offet is 324degres.
Injection phasing is base on TDC reference point so end of injection is about 180degres, right?

Trigger offset is 324 , but can we use negative value? -36 degres?
If -36degres trigger angle , injection phase will be about -180 degres end of injection.

Just realized that "engine sniffer" in rusEFI console is the best way to confirm behavior

Actually even TS logs have state of each injector as long as your data rate is high you would see relation to engine phase.