How to control output based on input conditions
Posted: Tue Oct 11, 2022 8:05 pm
Hi,
I'm new to rusefi and I'm currently working on a Proteus.
I started to read the doc but can't figure out what is the best way to configure an output based on inputs.
Example
If map is over 130 kpa and rpm over 3300, enable this output (to trigger a vsv valve).
From what I read, I need to use the LUA Script?
is there an other better way to do this?
Thanks
I'm new to rusefi and I'm currently working on a Proteus.
I started to read the doc but can't figure out what is the best way to configure an output based on inputs.
Example
If map is over 130 kpa and rpm over 3300, enable this output (to trigger a vsv valve).
From what I read, I need to use the LUA Script?
is there an other better way to do this?
Thanks