rusefi.com

Hi i have two vw bugs the bug with rusefi come with oem fuel injection , but i want to modify a little, so i add 1.4 rockers and i want to test some intakes , right now have a itb form suzuki and i have a turbo waiting to be installed , i killed my ignition coil so im in the proces to install an msd...

russian wrote:can you record a video of the ecu and car so that i put you on the official list?

yes of course

hi
befor i use rusefi i have a m$ and vems, and i use 5ms dwell with oem coil the have a built in igniter , but with rus efi turns vey hot, for now i cant discard a faulty coil and i need to measure with scope the time , any sugestion to verify my config
regrads

the bug starts now Wait a second, you've totally lost me to be honest. The bug starts using what ECU? 4 vanes evenly spaced on camshaft would be "custom 4/0" trigger wheel, this would work since the distributor would carry spark to the right cylinder. Ecu Frankenstein, ok i used one tooth...

hi problem solved the problem was the resistors , i solder 1206 with dont fit properly vs 0805 , and another issue is the volt divider for 12 volts sensing, i simply add a multi turn trimer and do the trick , the bug starts now one question , i use the hall sensor in the distributor which have 4 van...

Hi a little help needed with the IAT and CLT , without these sensors conected, the voltage is 5 volts, and 2.7.. in the procesor board, but in the console shows like a 70 degrees and in the messages shows unrealistic , when i plug the sensor the temp goes to the low side whit heat, what can i do bes...

Hi just received my Frankenstein pcb and some components nice labeled i plan to solder with hot air and paste maybe do an video to show the rusefi stuff and how easy is solder http://i143.photobucket.com/albums/r136/AldoQ/2015-05-08_20-57-50_299.jpg http://i143.photobucket.com/albums/r136/AldoQ/2015...

Hi
there is any BOM for the simulator??
best regards

In my case the 6 pin connector is already cut from the 4.2 sensor, so whatever is inside the connector I do not have. Am I screwed the connector have a cal resistor,so if you dont have the connector, you need a controller with free air calibration personally i have a JAW and SLC free form Alan both ...

Hi wow very fast response!!!!! I LIKE, very very much, rusefi have now a one more fan, i hope ths project grow much yes one wire for 4 hi z injectors, i can fire 4 channels at once and conect to one wire??? any type of map sensor are ok=??? (absolute presure 30 psi boost is i want) in the distribuit...

HI i want to ty rusefi but i want to be sure my convination is suported the bug is oem digifant fi map sensor inside the ecu, hall sensor in the dist with 4 window hall is active low( open collector), 4 injectors hi imp batch injection, pwm IAC valve, IAT,TPS sensor, and a temperature sensor in the ...

Hi
thanks
yes i read the wiki

now start to work with a frankenso in a bech and tray to make a can dash board
best regards

Hello from Mexico first, sorry for my bad english I have 2 vw bug one is 1995 is oem digifant but , now have a 1776cc turbo engine, first converted to megasquirt now running on vems with display second one is 1997 oem efi and motor i hope not for a longer, i planed to install a 87mm pistons with tec...