Hello,
I would like to know how to tune the ETB bias curve.
From what I thing would work would be to set the controller into open-loop mode and set a specific duty cycle and check the TPS value to which it corresponds.
Search found 3 matches
- Sun Mar 10, 2024 4:25 pm
- Forum: User Support
- Topic: ETB Bias curve tunning
- Replies: 1
- Views: 519
- Thu Jan 18, 2024 5:58 pm
- Forum: Dev: Hardware
- Topic: Wideband Controller: Fully Custom, no ASIC!
- Replies: 211
- Views: 649766
Re: Wideband Controller: Fully Custom, no ASIC!
Hello, I have two f0 boards which have two different behaviours, both running November firmware from mck1137/wideband. 1. Nerst voltage fluctuates depening on the applied oxygen (sensor over candle or lighter) afr sometimes jumps if nerst crossed over 450mV 2. Nerst voltage stays fixed at around 450...
- Fri Jan 05, 2024 2:18 am
- Forum: User Support
- Topic: How to tune MAP angle and window?
- Replies: 2
- Views: 13295
Re: How to tune MAP angle and window?
This might be helpfull found on some old forum. 90deg V4 engine.
- obraz.png (248.81 KiB) Viewed 13262 times