Search found 6 matches

by slokart_mx5
Thu Apr 07, 2022 8:48 pm
Forum: Tuning Support: Making it Run
Topic: NA6 AC and Clutch switch Function
Replies: 2
Views: 3133

Re: NA6 AC and Clutch switch Function

1. Yes those two stay highlighted in blue

2. I set those same settings and "clutch down" stay highlighted in yellow
by slokart_mx5
Sun Mar 27, 2022 9:04 pm
Forum: Tuning Support: Making it Run
Topic: NA6 AC and Clutch switch Function
Replies: 2
Views: 3133

NA6 AC and Clutch switch Function

This is a two part issue I am working on. 1. AC: I've compared my tune to another that has AC and this is what I have set for my AC settings. Screenshot 2022-03-27 155737.png With these settings the ac compressor stays engaged no matter what setting I have on my HVAC panel in the car, even if the bl...
by slokart_mx5
Sun Mar 27, 2022 8:43 pm
Forum: Tuning Support: Making it Run
Topic: NA6 Miata Dies After Cranking
Replies: 5
Views: 4792

Re: NA6 Miata Dies After Cranking

I meant to come back and post my fix but it has slipped my mind.

My issue ended up being that I did not have my fuel pump correctly jumpered at my AFM connector. I found the correct jumper configuration here under "wiring the peripherals" https://trubokitty.com/#/installation
by slokart_mx5
Sat Nov 27, 2021 9:06 pm
Forum: Tuning Support: Making it Run
Topic: NA6 Miata Dies After Cranking
Replies: 5
Views: 4792

Re: NA6 Miata Dies After Cranking

Thank you for the good detail! I don't see anything immediately wrong with the tune or log. Are you still running the stock injectors? If so, I assume the car still runs properly on the factory ECU? Yeah, it's still on stock injectors and it ran fine before I pulled the stock ECU. The only note wor...
by slokart_mx5
Sat Nov 27, 2021 8:15 pm
Forum: Tuning Support: Making it Run
Topic: NA6 Miata Dies After Cranking
Replies: 5
Views: 4792

NA6 Miata Dies After Cranking

Hello everyone, I'm very new to the tuning world and I'm having issues with keeping my car running after it cranks. I can get it to catch and idle for about two seconds before it dies out and I am unable to keep it alive with the throttle. I have tried comparing my cranking, base engine, and idle se...
by slokart_mx5
Tue Nov 16, 2021 2:33 am
Forum: Plug In Boards
Topic: NA6 board communication issues with Mac
Replies: 7
Views: 12993

NA6 board communication issues with Mac

I have a Hellen NA6 board for my 91 Miata. Before installing the board into the car I went through the steps on the set-up guide to have the board talk with TS. I successfully established communication between the board and TS. Once I installed the board in the car I started TS before cranking to te...