rusefi.com

Well, This long saga seems to have come to an end. I'm not quite sure why but its all good now. I looked through the whole ls output section of all the aux resuse pin's. Turns out that the schematics and my board off and the supposed solutions didn't quite work (0 ohm resistors and the 6.8k). I ende...

I should have clarified that my board had all the resistors for av6,av10,av8 and av9. I removed av6 and av9 resistor. However, I had no problems on the bench feeding those pins voltage and reading it on tuner studio (zero when it should be and 5v when fed). When I put it in the car im now getting 3....

Thank you so much Andrey for the lead on the resistors. The board schematic and my board were off. All i did was unsolder the resistors and I had perfectly working An Volt inputs. Either by this or next weekend, The midget should be running better than ever.

I did not realize that this was a thing. Sorry I forgot to tell you the exact pins. I tested a bunch of pins but the original setup that wasn't working was Pin 40-AN Volt 9 and Pin 32- AN Volt 6. I was using them for start/stop button and 02 sensor respectively.

Well we seem to have hit a road block with our ecu. Non of the non essential an volt pins seem to be working properly. I couldn't get the 02 sensor to read at all. This prompted me to take the ecu out of the car and bench test it. I have noticed that all of the aux reuse pins are acting the same and...

Hi, Im the blond guy in the images above. I've helped @captainavi with his Kswap Mr2 and now have helped Inert Goose with his Midget. We aren't using the cam sensors for triggering at all yet (it should be possible). I'd love to see vtec working on the mre, The car has a solid state relay setup that...