rusEFI
The most advanced open source ECU
Loading...
Searching...
No Matches
generated_outputs.h
Go to the documentation of this file.
1//DO NOT EDIT MANUALLY, let automation work hard.
2
3// auto-generated by PinoutLogic.java based on config/boards/m74_9/connectors/m74_9.yaml
4#pragma once
5
6Gpio GENERATED_OUTPUTS = {
7 Gpio::L9779_OUT_4, // Injector 1
8 Gpio::L9779_OUT_3, // Injector 2
9 Gpio::L9779_OUT_2, // Injector 3
10 Gpio::L9779_OUT_1, // Injector 4
11 Gpio::L9779_OUT_6, // Oxygen sensor 1 heater
12 Gpio::L9779_OUT_5, // EVAP solenoid control
13 Gpio::L9779_OUT_7, // Oxygen sensor 2 heater
14 Gpio::L9779_IGN_1, // Coil 1 (< +2.5v) / Coils 1,4
15 Gpio::L9779_IGN_3, // Coil 3 (< +2.5v) / Coils 2,4
16 Gpio::L9779_IGN_2, // Coil 2 (< +2.5v) (not populated)
17 Gpio::L9779_IGN_4, // Coil 4 (< +2.5v) (not populated)
18 Gpio::L9779_OUT_17, // Air compressor control
19 Gpio::L9779_OUT_14, // Secondary starter relay
20 Gpio::L9779_OUT_15, // FAN 1 relay
21 Gpio::L9779_OUT_16, // FAN 2 relay
22 Gpio::L9779_OUT_18, // Unknown out (OUT18)
23 Gpio::L9779_OUT_13, // Fuel pump relay
24// "Injector 1",
25// "Injector 2",
26// "Injector 3",
27// "Injector 4",
28// "Oxygen sensor 1 heater",
29// "EVAP solenoid control",
30// "Oxygen sensor 2 heater",
31// "Coil 1 (< +2.5v) / Coils 1,4",
32// "Coil 3 (< +2.5v) / Coils 2,4",
33// "Coil 2 (< +2.5v) (not populated)",
34// "Coil 4 (< +2.5v) (not populated)",
35// "Air compressor control",
36// "Secondary starter relay",
37// "FAN 1 relay",
38// "FAN 2 relay",
39// "Unknown out (OUT18)",
40// "Fuel pump relay",
41}
@ L9779_OUT_6
@ L9779_IGN_2
@ L9779_OUT_3
@ L9779_OUT_14
@ L9779_OUT_15
@ L9779_IGN_1
@ L9779_OUT_5
@ L9779_IGN_3
@ L9779_OUT_1
@ L9779_IGN_4
@ L9779_OUT_7
@ L9779_OUT_16
@ L9779_OUT_17
@ L9779_OUT_13
@ L9779_OUT_2
@ L9779_OUT_4
@ L9779_OUT_18